Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Dial-Peer problem

I have a basic international dial-peer (destination-pattern 011T). I am prefixing 011. For testing I have a CME running and have the PRI setup. I see on the CME that 011 is not being sent over. I have no forward-digit command in this dial-peer.

Has any one seen an issue with 011 not getting prefixed (even though it's in the statement)?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Dial-Peer problem

Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: Dial-Peer problem

Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.

Hope this helps, please rate post if it does!

130
Views
0
Helpful
1
Replies
CreatePlease to create content