I have a basic international dial-peer (destination-pattern 011T). I am prefixing 011. For testing I have a CME running and have the PRI setup. I see on the CME that 011 is not being sent over. I have no forward-digit command in this dial-peer.
Has any one seen an issue with 011 not getting prefixed (even though it's in the statement)?
Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.
Hope this helps, please rate post if it does!
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: