How can i divert one specific calling number ( ANI) to session target 2, when all other ANIs are going to session target 1 using voip dial peer?
Call is coming from pstn on pots and move to softswitch on voip dial-peer.
I have implemented following scenario...
My calling number is 512112152. Actually i rejected my ANI on rule 1000 and pass all other ANIs. then on rule 1001 i am passing my ANI. These two rules are shown below :
voice translation-rule 1000
rule 1 reject /^512112152/
rule 2 // // type any national plan any isdn
voice translation-rule 1001
rule 1 /512112152/ //
Then implemented these translation rules on translation profiles as :
voice translation-profile geo
translate calling 1001
voice translation-profile national
translate calling 1000
translate called 1550
Now pots dial peer is used to get the call from ANi from PSTN and dial peer is as :
dial-peer voice 102 pots
translation-profile incoming Remove-C
incoming called-number .T
Now Voip dial-peers are used to out the call to two different session targets. Dial peer 1001 is used to route all other calls to session target 22.214.171.124 and dial-peer 9002 is used to route call from ANI 512112152 to session target 126.96.36.199. Both these dial-peers are as :
there is only one incoming dial-peer and that is of POTS which is used to get all calls from PSTN irrespective of ANIs.
My issue is that one of my customer name GEO having its PRI 512112xxx. i want to divert all calls from this PRI to session target .197 of voip dial-peer 9002 but its not happening and all calls from PRI reading voip dial-peer 1001 and moving to session target .74
The translation profile which you are pointing out is only for removal of caharacter "C" as some of TDM exchanges send C with incoming number so we used that profile in pots dial-peer as :
voice translation-rule 1450
rule 1 /C/ //
voice translation-profile Remove-C
translate called 1450
Is this effect our answer address command used in dial-peer 9002 to divert ANI 512112152 to session target .197?
if not whats then, why 512112152 not reading 9002 voip dial-peer?
My only concern is that one of my customer name GEO having its PRI 512112xxx. i want to diver all calls from this PRI to session target .197 of voip dial-peer 9002 but its not happening and all calls from PRI reading voip dial-peer 1001 and moving to session target .74
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.