Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Dial Peer session target for 2 CCM 4.1 servers.

We have a Subscriber and a Publisher CCM 4.1 servers. I have set up my Dial Peers to use both of them. Basically I want to have it fall over to the other server and if one server is down for any reason and have it fall over automatically. I have an PRI coming into a Cisco 2851 router with IOS 12.4(9)T. On Call Manager I have defined it as an H323 gateway.

Here is my current config:

dial-peer voice 9802 voip

destination-pattern 235....

modem passthrough nse codec g711ulaw

session target ipv4:192.168.225.4

dtmf-relay h245-alphanumeric

codec g711ulaw

fax rate disable

no vad

!

dial-peer voice 2261 voip

destination-pattern 226....

modem passthrough nse codec g711ulaw

session target ipv4:192.168.225.4

dtmf-relay h245-alphanumeric

codec g711ulaw

fax rate disable

no vad

!

dial-peer voice 2262 voip

destination-pattern 226....

modem passthrough nse codec g711ulaw

session target ipv4:192.168.225.5

dtmf-relay h245-alphanumeric

codec g711ulaw

fax rate disable

no vad

!

dial-peer voice 9803 voip

destination-pattern 235....

modem passthrough nse codec g711ulaw

session target ipv4:192.168.225.5

dtmf-relay h245-alphanumeric

codec g711ulaw

fax rate disable

no vad

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Dial Peer session target for 2 CCM 4.1 servers.

take a look at this doc

H.323 Gateway Dial-Peer Configuration for Cisco CallManager Server Redundancy

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080094852.shtml

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2 REPLIES
Cisco Employee

Re: Dial Peer session target for 2 CCM 4.1 servers.

take a look at this doc

H.323 Gateway Dial-Peer Configuration for Cisco CallManager Server Redundancy

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080094852.shtml

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Dial Peer session target for 2 CCM 4.1 servers.

Thanks I think that is what I needed!

216
Views
0
Helpful
2
Replies
CreatePlease to create content