Hi I had two nice and simple dial peers working on two E1 lines.I used the preference command so that 1 would act as a backup. see below
dial-peer voice 1 pots
description local calls to isdn30
translation-profile incoming ddi2
incoming called-number .
dial-peer voice 2 pots
description calls to backup isdn
translation-profile incoming incomingddi
incoming called-number 201....
My problems started when my customer wanted to send 0800 number out on the backup line. I removed the two simple peers above and I expanded my dial peers and most outgoing calls started failing. It seems my dial peers are not matching. I attach the config that caused my problems because it easier to see. Take a look and tell me if you see why i cant Dial 0.07xxxxxxxx for example the call fails when i get to 0.07.
Could be that because you are using POTS, it will match on the 0.07... only only send out the ...... Any match on a POTS dial-peer will result in that actual matches number not being sent to line- add Forward ( the number of digits you need ) ???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.