Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dial special characters as prefix "*" and "#" in CME 7.1

Hi,

I'm looking how to set a CME in order to dial to PSTN  with * or # before digits

e.g  in order to dial  to local call to pstn  CME's user  should dial  *  as prefix and then the last 8 digits   and then  the discard * and route the call to digital

or analog trunk.

I know in CM server is possible but I haven´t seen  any example with CME.

If I set the following  dial-peer  how can I remove the * in ordet to make the call goes through ??

regards

dial-peer voice 91 pots

corlist outgoing local

description Local Calls

destination-pattern *[1-9].......

direct-inward-dial

port 0/2/0:1

forward-digits 8

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Dial special characters as prefix "*" and "#" in CME 7.1

Hi

These characters on standard touch-tone dial pads  can be used anywhere in the pattern. They can be used as the leading  character (for example, *650).

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html

Your configuration is correct. Since it is matching the destination-pattern * will be removed automatically, because exact match digits are removed while dialing out from POTS dialpeer.

Regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
2 REPLIES
Blue

Dial special characters as prefix "*" and "#" in CME 7.1

Hi

These characters on standard touch-tone dial pads  can be used anywhere in the pattern. They can be used as the leading  character (for example, *650).

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html

Your configuration is correct. Since it is matching the destination-pattern * will be removed automatically, because exact match digits are removed while dialing out from POTS dialpeer.

Regards

Ronak Patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
New Member

Dial special characters as prefix "*" and "#" in CME 7.1

Hi Ronak,

Thanks for  your answer. Yoou are right, it works . I have already tried.

regards

406
Views
0
Helpful
2
Replies
CreatePlease login to create content