Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dial, tone and dial

Hi there,

I have a situation where I need to dial an access code, hear a tone and then dial the extension number..

It happens in my remote site, where I'm using a SRST router with a E1 (qsig) with an Avaya PBX...

Destionations that I don't need to hear the tone before calling are working fine.

Is it a router config or a CUCM config ? (CallManager 4.2)

Any help ?

Thanks.

Andrei.

  • IP Telephony
2 REPLIES

Re: Dial, tone and dial

Hi Andrei,

You can control the dial tone from the route pattern configuration page

You can specify an access code and provide dial tone after this [ like 9 for outside calls ]

so it is from your CUCM config

But consider for any interference between these access codes and any configured DN in your network to not affect your dial tone

Wish this be helpful :)

New Member

Re: Dial, tone and dial

Hi !

I found the "Provide Outside Dial Tone" configuration in the Route Pattern..

I have this pattern: 8305547XXXX

How can I tell the CUCM that the tone should be after "830" ?

Thanks a lot.

Andrei.

201
Views
0
Helpful
2
Replies