Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DialPeer question

Hello folks

I have some issues with dial-peers

I have a 2811 running MGCP as the primary protocol and is registered to CCM 6.1(2).

for emergency calls, we are routing the calls through 2 local FXO ports, the ports show as registered in CCM, however in the gateway the dial-peer associated to the FXO port is showing up as down

I issued a no mgcp, mgcp and didn't work

I reconfigured the dial-peer as

dial-peer voice 101 pots

service mgcpapp

port 0/2/0

and still the same

could you please help me

2 REPLIES
Hall of Fame Super Silver

Re: DialPeer question

Is the port configured on CM properly? In the right port, etc? Does it show registered there? MGCP auto generate the dialpeer for you and you should not need to touch it on the GW, only CM config should be of your concern.

Chris

Re: DialPeer question

Please check 'show ccm | i Name' against the name you've entered on the MGCP gateway page and check for typos / missing domain name.

Otherwise, check 'show voice port summary' and 'show voice call summary' to make sure the ports are in an operational state.

Then, do a 'debug mgcp packet' and see what's up with the messaging, and see which side is rejecting the call. The gateway could be sending an "Unknown Endpt" or the CUCM could be sending back a 500 rejection message, among other things.

hth,

nick

124
Views
0
Helpful
2
Replies