Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DialPeer selection

Hi,

  I have the following dial peer configuration on an h323 gateway:

dial-peer voice 1 pots

translation-profile outgoing isdn_map

destination-pattern 911$

progress_ind setup enable 3

progress_ind progress enable 8

incoming called-number .

direct-inward-dial

port 0/2/0:23

forward-digits all

!

dial-peer voice 2 pots

translation-profile outgoing isdn_map

destination-pattern 9911$

progress_ind setup enable 3

progress_ind progress enable 8

incoming called-number .

direct-inward-dial

port 0/2/0:23

forward-digits 3

!

dial-peer voice 3 pots

translation-profile outgoing isdn_map

destination-pattern 9T

progress_ind setup enable 3

progress_ind progress enable 8

incoming called-number .

direct-inward-dial

port 0/2/0:23

!

dial-peer voice 100 voip

preference 1

destination-pattern 9... --> this is for testing

progress_ind setup enable 3

progress_ind progress enable 8

voice-class h323 1

session target ipv4:172.16.24.12

dtmf-relay h245-alphanumeric

no vad

!

dial-peer voice 110 voip

preference 2

destination-pattern [150].

progress_ind setup enable 3

progress_ind progress enable 8

voice-class h323 1

session target ipv4:172.16.24.11

dtmf-relay h245-alphanumeric

no vad

When I call a number by dialing 9305XXXXXXX, the choosen dial peer is 100 because it is the more specific dial peer and the call doesn't go anywhere because the router is in SRST mode. I configured the preference but that didn't help. My question is:

When the router is in fallback, doesn't it disable the voip dial peers?

What do I have to do to use the pots dial peers?

Thanks in advanced. RG

Everyone's tags (2)
1 REPLY
Hall of Fame Super Gold

DialPeer selection

On the Voip DP, configure "no huntstop".

628
Views
0
Helpful
1
Replies
CreatePlease to create content