interface BRI0/0/0 no ip address no ip redirects no ip unreachables no ip proxy-arp ip route-cache flow isdn switch-type basic-net3 isdn point-to-point-setup isdn incoming-voice voice isdn static-tei 0
How do these 3 interact? The port 0/0/0 in the dial peer is the voice-port. That is something I understand, but when it comes to voice-port --> interface BRI I get a little confused. Does the voice-port 0/0/0 use the interface BRI 0/0/0? And voice-port 0/0/1 use interface BRI 0/0/1 etc?
Think of the voice-port as (more or less) the physical layer and settings for it. The Interface is the logical higher layers for ISDN Q921/931. The dial-peer is a mechanism to address traffic to a port or an IP address or another device, in this case any number starting with 0.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.