Here is my dilema, may be a simple fix or solution:
Running CallManager 3.3(5)sr2a (man we need to upgrade) and we have a remote gateway with a DID coming into it. The telco is passing the last 4 digits to us, we are translating these to an internal number (example 8345 to 6547). My problem is the outbound call is passing the translated number (6547). How to I setup a translation to pass the full number out the gateway? If I try to add a new translation with the numbers already used, CallManager complains the numbers are already in use in that partition/route filter. Hope this makes sense and TIA.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.