DID/FXS Digits outpulsed different than digits actually recieved
Telco switch tech confirmed they are outpulsing 4 digits. "Debug vpm all" only shows me 3 and when configured for 3 works fine. Could there be a timing issue where the router is not ready to recieve the leading digit? If so are there some suggested timing commands.
I was testing late last night and did not capture a working debug output and had to move the analog ckts back to production dialogic board so if that is required can provide later.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...