Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DID in E1

How to config DID in E1?

8 REPLIES
Hall of Fame Super Gold

Re: DID in E1

Do you have PRI, and do you have callamanager, or what ?

Community Member

Re: DID in E1

I have PRI and also have CCM. I want to translate PSTN no. to internal extension no.

Example. PSTN no. xx-xxx-xxxx translate to internal extension no. yyyy

How to config in voice gateway router, or setting in CCM is more flexible ?

Community Member

Re: DID in E1

My system is C3845 with VWIC2-1MFT-T1/E1 IOS 12.4 and 4FXS-DID CCM 6.0

Hall of Fame Super Gold

Re: DID in E1

If you use mgcp, all the config is in the ccm.

If using h.323 or sip, you can config in router, ccm, or both.

Community Member

Re: DID in E1

If I used h.323, I need to create translation rule into gateway router for DID or any other solution ?

thank you.

Hall of Fame Super Gold

Re: DID in E1

As mentioned above, you can have the translation done either the router, or in the ccm. Really it depends on what you like better to configure.

Community Member

Re: DID in E1

I'm in a similar problem. I have CCME running on a C2851 with a VWIC-1MFT-G703. The Telco is providing 30 DID numbers through an E1 connection. (58500800 to 58500829)

At this time all calls are ringing to operator because I set a "connection plar" command in the voice-port 0/0/0:1 which is the VWIC card.

I understand I should define DID numbers as secondary numbers in the corresponding ephone-dn's. I tried but unsucessfully. So, I guess I'm missing something.

Thanks in advance

Hall of Fame Super Gold

Re: DID in E1

No is not said that you have to create secondary numbers.

You can also use dialplan-pattern under telephony-service.

The syntax of the command really depends on how you configured the extensions numbers.

Another alternative is translation-profile and rule under voice-port.

265
Views
3
Helpful
8
Replies
CreatePlease to create content