DID numbers on PRI different from CUE AA pilot numbers
I have a PRI with 4 public DID numbers. The CO is sending 7 digits (all four numbers are completely discontiguous). These 4 numbers each need to go to 4 different CUE AA pilot numbers. I think they need to be translated. I'm not sure what the best approach is for this problem and what the detailed configuration should look like. Can anybody help.
Re: DID numbers on PRI different from CUE AA pilot numbers
Thanks again. But can you confirm the configuration below is correct with your suggestion:
voice translation-rule 1
rule 1 /5551234/ /301/
rule 2 /5552345/ /302/
rule 3 /5553456/ /303/
rule 4 /5554567/ /303/
voice translation-profile PSTN_CUEAA
translate called 1
translation-profile incoming PSTN_CUEAA
dial-peer voice 555 pots
incoming called-number .
dial-peer voice 300 voip
session protocol sipv2
session target ipv4:192.168.1.1
Also, can you help me to understand why the DP only has a '.' for the incoming called number? If the translation rule is in effect on the voice-port won't the dialed numbers be 301,302, and 303? Doesn't seem to match the '.'. I was thinking incoming called number 30. or 30[1-3]. Sorry to belabor this only for my understanding.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.