Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

DID on E1 PRI ISDN

Dear All,

I want to configure DID on E1 PRI

I configured the PRI as follows and I need help to configure the DID on it.

isdn switch-type < primary-net5 >

controller e1 0/2/0

framing <crc4>

linecode < hdb3 >

pri-group timeslots < 1-31 >

3 REPLIES
Hall of Fame Super Gold

Re: DID on E1 PRI ISDN

Have you ever configured voice before? Do you know about things like dial-peers, translation-rules, etc.?

Because if you don't, the best is that you engage a reputable professiona or UC certified Cisco partner for the job.

Re: DID on E1 PRI ISDN

Yes, I know the dial-peer very well and I put the bellow configration of DID and didn't work

dial-peer voice 1 pots

corlist outgoing local-VM

description ** Inside Cairo **

destination-pattern 9[2-9].......

incoming called-number .

direct-inward-dial

port 0/2/0:15

forward-digits 8

Even I put connection plar 100 on the voice-port 0/2/0:15 to send all the incoming calls to the secrtary office, when I remove this command any one calls the company a message tells him that this number is not correct and when I put it back it rings !!

also I tried these configrations and fail

voice translation-rule 1

  rule 1 /^226492/ /2/

  exit

voice translation-profile pstn-in

  translate called 1

  exit

voice-port 0/2/0:15

  translation-profile incoming pstn-in

Blue

DID on E1 PRI ISDN

HI

What is the DID number you are hacing and send us debug voip ccapi inout and ISDN q931 output.

regards

Ronak patel


Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
247
Views
0
Helpful
3
Replies
CreatePlease to create content