Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DID problem

I have a pbx which connected to PSTN.

the pbx is connected to a router via ISDN E1.

when my users dial 9 they want to hear pstn dial tone.

right now my users can make call with pstn without hearing dial tone.

for solving this issue I have provided

this config:

dial-peer voice 5 pots

incoming called-number 9

port 0/0/1:15

after this config they can hear a dial tone after pressing 9

but the problem is I have other dial-peer too..

now they dial any number then they can hear dial tone!!!

when I provided DID on other dial-peer execpt above dial-peer

now the problem came back and they can not hear dial-tone again after pressing 9

please let mw know your issue or hints.

4 REPLIES
New Member

Re: DID problem

Hi

If you have been using CUCM i suppose that there is an option in the route pattern configuration page to provide outside dial-tone.

Please do check if this option helps you...

Regards

kumar

New Member

Re: DID problem

Dear kumar

thank you for youre response.

but in my project there in sno room for CUCM

do u have anu other idea on this issue?

regards

New Member

Re: DID problem

No Dial Tone On Digital Voice Port

Check to see if the dial-peer pots are configured with the direct-inward-dial command. This command disables dial tone from the voice port. For example:

dial-peer voice 1 pots

destination-pattern .T

direct-inward-dial

port 0:DIf you remove the direct-inward-dial command from the dial-peer pots, then the digital voice port provides dial tone.

Also can you please upload the config for that especifically POTS.

HTH

if this helps, please rate

Viri

Re: DID problem

u can make dial peer as 9 only whihc open the line to the pbx then the pbx should handel the dialed number

or send the 9 to the pbx and configure the pbx to open the pstn line if 9 dialed then after user dial 9 will go to the pstn and then can dial normally

116
Views
0
Helpful
4
Replies
CreatePlease to create content