12-04-2008 05:59 AM - edited 03-15-2019 02:54 PM
I have a pbx which connected to PSTN.
the pbx is connected to a router via ISDN E1.
when my users dial 9 they want to hear pstn dial tone.
right now my users can make call with pstn without hearing dial tone.
for solving this issue I have provided
this config:
dial-peer voice 5 pots
incoming called-number 9
port 0/0/1:15
after this config they can hear a dial tone after pressing 9
but the problem is I have other dial-peer too..
now they dial any number then they can hear dial tone!!!
when I provided DID on other dial-peer execpt above dial-peer
now the problem came back and they can not hear dial-tone again after pressing 9
please let mw know your issue or hints.
12-04-2008 10:58 PM
Hi
If you have been using CUCM i suppose that there is an option in the route pattern configuration page to provide outside dial-tone.
Please do check if this option helps you...
Regards
kumar
12-05-2008 12:38 AM
Dear kumar
thank you for youre response.
but in my project there in sno room for CUCM
do u have anu other idea on this issue?
regards
12-06-2008 04:28 PM
No Dial Tone On Digital Voice Port
Check to see if the dial-peer pots are configured with the direct-inward-dial command. This command disables dial tone from the voice port. For example:
dial-peer voice 1 pots
destination-pattern .T
direct-inward-dial
port 0:DIf you remove the direct-inward-dial command from the dial-peer pots, then the digital voice port provides dial tone.
Also can you please upload the config for that especifically POTS.
HTH
if this helps, please rate
Viri
12-08-2008 02:33 AM
u can make dial peer as 9 only whihc open the line to the pbx then the pbx should handel the dialed number
or send the 9 to the pbx and configure the pbx to open the pstn line if 9 dialed then after user dial 9 will go to the pstn and then can dial normally
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: