I greatly appreciate your reply its helped me have a better understanding,
The last part of my question is, if I create the route pattern to go to the GW from CUCM, in order for the CUCM to communicate with my router through the route pattern, I need to connect an additional T1 crossover cable (from 6608 to VoiceT1 router) in order to allow this communication to work...?
If this is correct ... should I be searching on documentation in regards to setting up a T1 trunk for communication between CUCM > 6608 > Router ?
If you use a XOVER cable to connect the 6608 and the T1 router you will be emulating a trunk.
I have this at my lab which i use to emulate a PSTN connection between 2 clusters
cluster 1 has a 6608 with MGCP and using an XOVER cable to connect it to a T1 PRI on a 2851 which i control using H323 and that routes call to cluster 2.
but in this case i have 2 clusters, are you going to have the 6608 and the router in the same cluster?
is the router already configured? if so, H323 or MGCP?
if both T1s are going to be in the same server, you can configure each GW in the CUCM server, use a translation pattern to change the DID to another DN which will be routed thru a translation pattern which uses the router.
CUCM will handle all the signaling and the 6608 will send the RTP directly to the router
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...