Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DID trunk with call manager 4.1(3)

I am working on configuring 4 DID trunks with CCM 4.1.3. I have the voice ports configured as DID and wink-start, but am not sure how to configure call manager to use these. Are they configured as FXO or FXS? The provider is stating that they are not receiving a wink and therefore calls are not crossing. Any ideas???

The card being used is a 4 FXS/DID

a "show voice port" confirms that it is a DID using wink start

2 REPLIES
Community Member

Re: DID trunk with call manager 4.1(3)

DID trunks use FXS. Once you enter the command "signal did wink-start" it configures the voice port for FXS. That is all that is needed on the voice port. Check the cabling. If you have the pairs crossed, that will definately cause a problem.

Community Member

Re: DID trunk with call manager 4.1(3)

It is my understanding that H323 must be used with 4.1(3).

Dial-peers need to be configured along with a new H323 gateway. Does this sound correct?

139
Views
0
Helpful
2
Replies
CreatePlease to create content