Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

different dial-peer for different calling numbers

Hello,

I have a dial-peer with "destination-pattern like 00033T"

to redirect these call via voip to another CCME in Frans.

But, it same that with ATA + analog fax, I have a problem, sending not possible.

To find a working workaround, I would to use this dial-peer only for the phones.

And define another dial-peer for the ATA+Fax.

But how is it possible to find the good dial-peer for that ?

Is it possible to say that for calling number xxx and yyy, use dial-peer 1, else, dial-peer 2 ?

Thx

3 REPLIES
New Member

Re: different dial-peer for different calling numbers

You can try it using cor ("class of restriction") one of the dial peer would be in a cro class reachable by the ata and another in a cor class reachable by the ip phones.

Hall of Fame Super Gold

Re: different dial-peer for different calling numbers

Hi,

I did not understood your problem too well, but if you need to do routing based on calling number, yes it's possible. See:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml

Note that is the ATA is in SCCP mode, you will need to configure the translation-rule at ephone-dn level.

Please remember to rate all useful posts using the scrollbox below!

New Member

Re: different dial-peer for different calling numbers

thx all

The response with cor is exactly what I asked.

But at lunch time :), I find the solution myself, it's similary to the solution of p.bevilacqua

... and in my case, the only thing to do that is cha nging a 0 to 9 ... all other thing are implimented in the past ...

Fur the future : More lunch time => more work

111
Views
0
Helpful
3
Replies
CreatePlease to create content