Yes, you can configure a route pattern with more than one digit before the dot. You can have different route patterns with different number of digits before the dot.
The secondary dial tone has no relation to where the dot is placed in the route pattern. When a user starts dialing a number, the moment the CallManager finds the perfect match, it plays the outside dial tone.
For example, if you a route pattern 98.XXXX and there is no other route pattern starting with a 9, when the user dials 9, he will immediately here the outside dial tone.
If there is another route pattern starting with 9 (say 911), the user will hear the outside dial tone after he presses 98, because that is when the CallManager finds the perfect match.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...