Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Direct-Inward-Dial setup

I have a New T1 im trying to set up for Direct-Inward-Dial and I can not get this working. I can make outbound calls but not receve any incoming. I have verfiyed that there is a translation pattern and it exists. I have a new Partion and CSS for this as well. I am expection 10 digits coming from the PSTN and sending out 4 to the PSTN. Any thoughts?

My gateway is an H323 running catos if that helps

3 REPLIES
Hall of Fame Super Silver

Re: Direct-Inward-Dial setup

Please post your router config.

Is this a PRI? If so post output of "debug isdn q931"

Chris

New Member

Re: Direct-Inward-Dial setup

Chris,

This router is runnig CATOS and it is an mgcp gateway not a H323 as I had stated here is the shrun of the mod/port as well we are using mod 4 port 2

#module 4 : 8-port T1

set port voice interface 4/1 dhcp disable 172.20.23.221 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/2 dhcp disable 172.20.23.222 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/3 dhcp disable 172.20.23.223 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/4 dhcp disable 172.20.23.224 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/5 dhcp disable 172.20.23.225 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/6 dhcp disable 172.20.23.226 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port voice interface 4/7 dhcp disable 172.20.23.227 255.255.254.0 vlan 22 tftp 172.20.18.2 gateway 172.20.23.254

set port disable 4/8

set port name 4/3 Verizon

set port name 4/4 Verizon

set port name 4/5 Verizon

set port name 4/6 AT&T

set port name 4/7 AT&T

Bronze

Re: Direct-Inward-Dial setup

Assume if you have 4 digits for your extension.

Can you confirm that under Gateway at CCM web admin page. Please you select 4 at Significant Digits. And make sure the Calling Serach Space has patition that use at Phone Line?

Ken

424
Views
0
Helpful
3
Replies