Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

direct-inward-dial & sip trunk

Hi,

How can I forward incoming call from sip server to cme to one of the internal numbers?

In fxo and e1 channel DID can be configured and there's no such command under "dial-peer voice voip"

dial-peer voice 1 voip

translation-profile incoming SIP_IN

session protocol sipv2

session target sip-server

session transport udp

incoming called-number XXXXXXX

voice-class codec 1

dtmf-relay rtp-nte

no vad

TIA

5 REPLIES
Hall of Fame Super Silver

direct-inward-dial & sip trunk

So, is your desire to configure PLAR type of config where are calls get routed to the same destination?

Or simply route calls according to received DNIS digits?

Chris

New Member

direct-inward-dial & sip trunk

Hi Chris,

I wanted to route calls according to DNIS. The above config worked with the right translation-profile, now I understand

that no DID is needed for SIP incoming call.

Thank you.

direct-inward-dial & sip trunk

are you using CME or CUCM?

Thanks

Hall of Fame Super Silver

direct-inward-dial & sip trunk

All you need to do is simply create matching dial peers with destination-pattern, if this is all on CME as long as the called numbers match the extension you should not need anything, if you need to translate digits then you have couple of options:

use translation rules

apply  dialplan-pattern to telephony-service configuration.

Chris

New Member

direct-inward-dial & sip trunk

With CME if i did want to configure a PLAR type of config on an incoming SIP trunk where are calls get routed to the same destination what would i need to to?

902
Views
0
Helpful
5
Replies