Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Directory Numbers in Bulk

Hello,

How can I pull directory number in bulk from Call Manager. I have a list of over 700 numbers and I would like to check if they exist in the Call Manager. How can I do it in bulk instead of one by one?

Thanks,

Marcin

  • IP Telephony
5 REPLIES
Hall of Fame Super Red

Directory Numbers in Bulk

Hi Marcin,

One of the better reports comes from this section of CUCM which

shows all configured DN's

From CUCM admin Call Routing > Route Plan Report and once it loads

up look at the top right hand corner of the page for "View in File" this will allow

you to save a copy in .csv format

And then I would go to Call Routing > Route Plan Report> Unassigned DN's

This should give you a good overview.

Cheers!

Rob

Cheers!

Rob

"A smile relieves a heart that grieves" 

- Stones

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
New Member

Directory Numbers in Bulk

Thanks Rob,

But what if I need to do some updates to all of those DIDs, let's say put them all in different partition or CSS. Is there anyway to do it in bulk?

Thanks so much...

Hall of Fame Super Red

Directory Numbers in Bulk

Hi Marcin,

You can do changes in bulk using BAT;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/9_0_1/CUCM_BK_C22BD805_00_cucm-bulk-administration-guide-90.pdf

Cheers!

Rob

"A smile relieves a heart that grieves" 

- Stones

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
New Member

Directory Numbers in Bulk

Thanks Rob,

I went thru all the options in 'Bulk Administration' menu and I was not able to find a way to pull specific DIDs in bulk.

The  only way i found to update the directory numbers is in 'Find and List  Directory Numbers To Update' but there you can only update 10 numbers at a  time.

Do you have any suggestions?

Cheers,

Marcin

New Member

Directory Numbers in Bulk

Bulk export phones will give you all phone details.

This generates a TAR with the phone.xsv and header file.

From this you could filter the on the DN's (in phone.csv) you want to change.

Make updates on filtered phones/dn's.

Repack the TAR upload, Bulk import with overwrite option.

This can make unitended changes if you are not careful, aka remove phones from the csv you do not want to change. Using BAT for this overwrite can be erratic depending on version of CUCM. I would suggest change on 1 or 2 phones first to test then proceed.

Also remember to deal with the Unassigned DN's depending on your dial-plan

Mike

185
Views
0
Helpful
5
Replies