Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Disabling CME Barge Tone

CME 7.0(1) - 12.4(22)T.

Is it possible to disable the tone that is heard when using the cBarge feature?

1 REPLY
Hall of Fame Super Red

Re: Disabling CME Barge Tone

Hey Josh,

Good question! Because cBarge is essentially an AdHoc Conference, this tone is related to the Conference Join/Leave Tones. To disable the cBarge tone you would have to disable the Conference Join/Leave Tones.

Barge (Conference Barge)

The Barge feature enables phone users to join a call on a shared octo-line directory number by pressing the Cbarge soft key and converting the call to an ad hoc conference. This feature uses a hardware conference bridge configured in Cisco Unified CME. When the initiator barges into a call, an ad hoc conference is created between the barge initiator, the target party, and the other party connected in the call. Parties see the call information on their phone displays and, if the conference join tone is configured, hear a tone.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebarge.html

SCCP: Configuring Join and Leave Tones

To configure tones to be played when parties join and leave ad hoc and meet-me conferences, perform the following steps for each tone to be configured.

SUMMARY STEPS

1. enable

2. configure terminal

3. voice class custom-cptone cptone-name

4. dualtone conference

5. frequency frequency-1 [frequency-2]

6. cadence {cycle-1-on-time cycle-1-off-time [cycle-2-on-time cycle-2-off-time] [cycle-3-on-time cycle-3-off-time] [cycle-4-on-time cycle-4-off-time] | continuous}

7. end

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeconf.html#wpxref76692

dualtone

To enter cp-dualtone configuration mode for specifying a custom call-progress tone, use the dualtone command in custom-cptone voice-class configuration mode. To configure the custom-cptone voice class not to detect a call-progress tone, use the no form of this command.

dualtone {busy | conference | disconnect | number-unobtainable | out-of-service | reorder | ringback}

no dualtone {busy | conference | disconnect | number-unobtainable | out-of-service | reorder | ringback}

Syntax Description

busy

Configure busy tone.

conference

Configure conference join and leave tones.

disconnect

Configure disconnect tone.

number-unobtainable

Configure number-unavailable tone.

out-of-service

Configure out-of-service tone.

reorder

Configure reorder tone.

ringback

Configure ringback tone.

http://www.cisco.com/en/US/docs/ios/voice/command/reference/vr_d2.html#wp1452512

Hope this helps!

Rob

602
Views
0
Helpful
1
Replies
CreatePlease to create content