I have a Cisco 2821 with two PVDMII-32 DSPs in it, an EVM-HD module chock full of FXO/FXSs and a PRI, and a data T1.
I no longer need the EVM-HD module, and it's taking up DSP resources. I would like to free them up for use by a conference bridge, but can't figure out a way to relinquish the DSP resources without physically removing the module (remote site). Anyone know of a way to "disable" an EVM-HD module from using DSP?
Yes, that's what I want to do... I have enough PVDM2 onboard to do what I want... I simply want to avoid having a field resource remove the EVM-HD module that is taking away valuable DSP-resources that I could put to good use otherwise!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.