I want total silence when putting a person on hold so i disable music on hold on my CUCME 7.0(1) but now i get the Tone on Hold. Every few seconds i hear a beep tone. Is there a way to disable the tone on hold on my system.
I've already done this. The problem is that i have two CUCME's that call each other using G729 and i do not have any resources available to do transcoding so users hear the tone on hold instead of the silent moh.Also because its a WAN connection i cannot switch over to ulaw.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...