Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Disconnect FXO on H323 gateway

Hi,

we have CUCM 7 with ip phones using cisco router 2811 as voice gateway to make calls to PSTN through trunk of FXO's.

Sometimes there is sudden failure on the CO line connected to the FXO(the reason from PSTN), can we confiugre the router to discard the FXO port from being chosen during failure of FXO and let it back to work again incase of returning service to CO line.

1 REPLY

Re: Disconnect FXO on H323 gateway

Hello,

Yes. Configure hunt groups.

Read this chapter from Dialpeer configuration Guide:

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dp_confg.html#wp1068229

Hope to help, please rate the post if it does.

Kind regards,

- Adrian.

145
Views
0
Helpful
1
Replies