I am using call manager 7.x and integrting with a thrid party legacy PBX, that PBX system is forwarding digits but not caller name, can I load persoanl address book on all phone sets so when user get call from PBX system, it will translate phone number to caller name and dispaly the caller name instead of phone number.
For H3.23 integration, a card is requried, that is not available for that PABX in the market, really its make life difficult and required such intelligent feature, that can solve a lot integration issues with thrid party exachanges, using BAT tool we can load address books on phone sets or through outlook or active directory synshronization, we could get our objective, in fact we need a feature like mobile phone, where adress book works for us.
Yes, you're right. It's pretty ugly to configure and "out of the box" can only support (from memory) 200 names. I did hack the script to increase this, and I also had to write my own script to generate the service parameters in the correct format.
It also seems to create an issue if the target number you are dialling is at the other end of a SIP trunk from CUCM. I'm not sure why, but the call gets rejected. I've never really had the time to look into why.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.