Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Display Name on IP Phone

Hi,

Can any one tell me how to set the settings on CUCM(7.1), where i can define only the name to be dipslayed on IP phone & not the DN while calling to other person.

I tried changing the settings on UDP


Device > Device Settings

Display(Internal Caller ID)-  Just put in the text name
ASCII- text name

Line Text label- with text name + DN
ASCII-with text name + DN

Tried Similar Settings on Phone settings
Device > Phone

Any suggestion , will be helpful

Navin

6 REPLIES
Cisco Employee

Re: Display Name on IP Phone

Use a translation pattern in between and choose to restricted.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Display Name on IP Phone

Hi,

Thanks for  the reply

I tried as suggested on translation Pattern. But then it still display the DN, along with the name(text)

e.g. from TEXT NAME

              (XXXXX)DN

Navin

Re: Display Name on IP Phone

i think the translation pattren will block the DN and name you will see the call from unknown !

i think use translation pattren as java suggested you

but instead of chose to ristrict the number use calling number trasformation mask and make for example 00000 or any number like main offic number

in this case the name will be shown and the number will be not dial able

good lcuk

if helpful Rate

New Member

Re: Display Name on IP Phone

Solution with translation pattern is good, but

1) if phone A calling phone B and you want phone A not see phone B number (or name). You have to set 'Connected Line ID Presentation' (or 'Connected Name Presentation') to 'Restricted'

2) if phone A calling phone B and you want phone B not see phone A number (or name). You have to set ‘Calling Line ID Presentation’ (or ‘Calling Name Presentation’) to ‘Restricted’.

Dariusz

New Member

Re: Display Name on IP Phone

Hi Darius,

As told above by Javalenc, i tried configuring the same.

The display format on IP Phone while calling to user "B" still shows as

from TEXT(name)

        XXXXX(DN)

we require only name to be displayed & not the DN.

regds,

Navin

Re: Display Name on IP Phone

are you  sure your call going through translation not direct to the phone

give the phone CSS that dos not has access directly to the other phone only has access to the translation pattren

give the translation pattren CSS has access to other phones

make sure you have it like this to make sure your call going through the TP not direct

good luck

if helpful Rate

2153
Views
4
Helpful
6
Replies
CreatePlease to create content