Displaying a calling number at Cisco IP Phone depending on it's location

[vyacheslav.k]

Help me, please, with following problem:

There is a CUCM6.1

CUCM <--> GW2821 <<-E1->> PSTN

There are two different extensions for a local calls and calls between cities.

For a local call an IP phone abonent uses 9<tel num>

For a call to another city IP phone abonent uses 8<city code><tel num>

When a user of IP phone receives a call it is dispayed: 8<city code><tel num> (just adds 8 before 10 digits)

how to do on CUCM that the call will display like 9<tel num> if a user receives it from a local city and 8<city code><tel num> in other cases?

[paolo bevilacqua]

Are you using H.323 or MGCP ?

[vyacheslav.k]

MGCP

[Nicholas Matthews]

I would take a look at these advanced CUCM service parameters:

Incoming Calling Party National Number Prefix - Phone

Incoming Calling Party International Number Prefix - Phone

Incoming Calling Party Subscriber Number Prefix - Phone

Incoming Calling Party Unknown Number Prefix - Phone

This appears to be what you're looking for.

-nick

[vyacheslav.k]

Where are there these parameters in? System -> Service Parameters ?

Should I install a dial plan for my country to use it ?

[iptuser55]

It is not dependent on a dial plan , you just need to make sure what parameter is used of what type of call. Also it is a glabal setting so if you have a clutser across countries or different access codes for sites then it will not work for you

[vyacheslav.k]

maybe is there another way to do it ?

something like conditions, for instance, if a caller number is (2822)532123 then display it on phones as 8(2822)532123, but if a caller number is (2800)234412 display it as 9234412 ?

are translation rules convenient for this task?