Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

DMA upgrade issues

Hi,

Having some issues upgrading from 4.1.3sr5 to 6.X. initially we were going to upgrade to 6.1.1a so ran theDMA tool for this. Apart from a few user errors the DMA was successful. But when we build the CM the build failed importing the DMA info. TAC case opened but we can see no reason for the failure.

So I uninstalled DMA 6.1.1 and installed DMA 6.0.1 an ran this. With the intention to patch up to 6.1.2. I havnt used it on the build yet but get the following information when finished.

Status: Backup - Successful. Validation - Failed.

I will try tommorrow night upgrading in a lab to check before the live upgrade. Anyone seen this error before

Thanks

Paul

2 REPLIES
Cisco Employee

Re: DMA upgrade issues

lots of reasons for that error, you would need to review the DMA logs to find the exact cause of the error

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Bronze

Re: DMA upgrade issues

Javalenc,

I take it this is just the logs highlighted in the DMA install guide. I will pull these off tommorrow and have a look.

Regards

Paul

129
Views
0
Helpful
2
Replies