Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Do we require a return path from cme to ccm cal from ccm

I have a ccm 7 i config it to route call to cme at one location through wan  ,but i tested there is no answer thr destin phone is ringing but no reply i heard a fast busy signal  , i want to know do we reqire a retun path to ccm from ccme

thank you

3 REPLIES
Cisco Employee

Re: Do we require a return path from cme to ccm cal from ccm

The setup is pretty easy

Config CME as H323 GW in CUCM and then use it for the route pattern doing whatever digit manipulation is required.

Then in CME configure a voip DP pointing to CUCM for calls the other way.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Do we require a return path from cme to ccm cal from ccm

i do made a call  c

ucm to cme when did i was able to get connected but i dont understand

this is possible even if i dont have the dial-peer configured on cme how the

calls cme back to cucm

Bronze

Re: Do we require a return path from cme to ccm cal from ccm

When you are doing a phone call from the cucm to the cme you are doing this

CUCM----route pattern----cme

The CME match the default dial peer as the incomming one, and afther that matches the outgoing dial peer and routes the call.

At the moment the CME is trying to call the CUCM the cme do not know the the path to call the CUCM since does not have an outgoing dial peer pointing to that.

In order to fix the problem you just need to add a voip dial peer pointing to the CUCM

I hope this will be helpfull.

Regards,

Luis

183
Views
0
Helpful
3
Replies
CreatePlease login to create content