Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Doubt about Hunt Group

Hi Guys,

I would like know if is possible to do the following configuration:

I Create a line group with 03 Directory Numbers. For example 1000, 1001 and 1002. The ring 1000 and not response, ring 1001 and not response too, ring 1002 and give busy tone. It's possible configure to return the call directory number 1000 again and repeat the process?

Thanks,

Wilson

3 REPLIES
Hall of Fame Super Red

Re: Doubt about Hunt Group

Hi Wilson,

You can set up a second Line Group that contains the same DN's/Members and link this second Group in the Hunt List.

Switch the rule on the first Line Group to, Try next Member;then try next Group in Hunt List

This will then cycle through the members a second time (I just tested this out in our lab a little while back) :)

Hope this helps!

Rob

New Member

Re: Doubt about Hunt Group

Hi Rob,

I am sorry, but, the Customer would like know if it's possible to do the same group. It's possible?

Thanks,

Wilson

Hall of Fame Super Red

Re: Doubt about Hunt Group

Hi Wilson,

Maybe I didn't explain this properly :)

This second Line group contains the "exact" same members, so it is the same group. This is the only way to cycle through these members a second time.

Hope this helps!

Rob

120
Views
4
Helpful
3
Replies