Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

DPA 7630 to 6.1(2) reports registration rejected error db config

DPA 7630 to 6.1(2) reports registration rejected error db config. I have auto registration enabled on subscriber that DA is pointed to.

Worked fine in 4.1(3)

54491 04:15:47 194 W CSSP 11: CallManager connection has gone down

54492 04:15:47 134 W CSSP 14: CallManager connection has gone down

54493 04:15:47 111 W CSSP 12: CallManager connection has gone down

54494 04:15:48 216 W CSSP 5: CallManager connection has gone down

54495 04:15:48 150 W Octel/CM 11: CallManager register reject: Error: DB Config

54496 04:15:49 855 W Octel/CM 14: CallManager register reject: Error: DB Config

54497 04:15:49 190 W Octel/CM 12: CallManager register reject: Error: DB Config

54498 04:15:49 190 W CSSP 25: CallManager connection has gone down

54499 04:15:49 11 W CSSP 1: CallManager connection has gone down

54500 04:15:49 14 W Octel/CM 5: CallManager register reject: Error: DB Config

54501 04:15:49 467 W Octel/CM 1: CallManager register reject: Error: DB Config

54502 04:15:50 210 W CSSP 6: CallManager connection has gone down

3 REPLIES
Green

Re: DPA 7630 to 6.1(2) reports registration rejected error db co

Which model of Phones in CUCM you have?

DPA version?

Re: DPA 7630 to 6.1(2) reports registration rejected error db co

Just a thought, but have you configure DNS on the CUCM 6.1.2? Previously on CUCM 4.1.3 you may have been using local hosts files to resolve the DPA hostname?

The reason I ask is that the host name is the device name sent to the CallManager with the port number appended to it when the DPA registers its ports with CallManager.

Hope this helps

Allan.

Re: DPA 7630 to 6.1(2) reports registration rejected error db co

I opened a TAC case. The auto-registration was resolved by changing from 1.3(1)ES6.1 to dpa-main.1.3(1)ES9.tar.

226
Views
0
Helpful
3
Replies