I would like to know what encryption algorithm the DRS uses when generating the .TAR files.
The Disaster Recovery System Administration Guide for Release 8.6(1) tells me:
Be aware that your backup .tar files are encrypted by a randomly generated password. This password is then encrypted by using the cluster security password and gets saved along with the backup .tar files. You must remember this security password or take a backup immediately after the security password change/reset.
But I can't figure out what algorithm exactly is used to encrypt the TAR-File (e.g. 256-bit AES, 3DES etc.)
Is there anything in the documentation I missed or does anyone can help me with that?
I'm currently writing an internal security document for one of my customers describing the security relevant parameters of the Voice Infrastructure. That document is needed for the works committee and one part is the backup-system and the encryption method is uses.
So the reason for my question is more political than technical.
Do you have an idea where I can get this information? (PDI?)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.