Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
240
Views
0
Helpful
1
Replies

DS1 reset causes remaining DS1s to unregister - 2851

bfollmer1
Level 1
Level 1

‎10-06-2009 06:56 PM - edited ‎03-15-2019 07:56 PM

Hello,

I have a total of 5 DS1's configured on 3 VWIC interfaces. One of the T1's is configured E&M and is used a tie line to a remote PBX. If I have an issue with the tie line T1 and reset it from the CM, it will register like it is suppose to but will cause the other 4 - T1's to unregister. If I reset those T1's(VWIC one and two) they will register and the T1 on VWIC 3 will go down. This will continue until I either reboot the gateway or do a shut / no shut on that interface.

If you have encountered a similar issue, please let me know what had to be done to reslove. - - Thank you...

Labels:
0 Helpful
1 Reply 1

Nicholas Matthews
Level 9
Level 9

‎10-06-2009 07:42 PM

Haven't seen anything like this on recent IOS. If you're on 12.3 code up to about 12.4(11)T this could be a bug. But 15T and later there shouldn't be anything like this that is a known issue anyways.

-nick

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents