Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DSP calculation in SRST mode for ephone

Hi,

i have 2921 gateway with PVDM3-64 and 12 FXO ports. I am using the gateway as SRST and for PSTN calls. I have a confusion about the DSP calculation for e-phones (are they utilizing any DSP resorce and how much?) note that i have max-ephone 25 and max-dn 50

are the DSP resources utilized all the time in case of SRST active and in case the phones are registered to the call manager cluster?

regards,

Ibrahim

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: DSP calculation in SRST mode for ephone

Ephones have no bearing DSP usage.  DSP's are utilized when an IP leg needs to be translated to a POTS leg, or for the use of hardware conferencing/transcoding.  So, the number of FXO lines will factor into the number of DSP's needed, as will the need for any hw conferencing.

You can check your DSP needs with the following tool:

http://www.cisco.com/web/applicat/dsprecal/dsp_calc.html

2 REPLIES
Cisco Employee

Re: DSP calculation in SRST mode for ephone

Ephones have no bearing DSP usage.  DSP's are utilized when an IP leg needs to be translated to a POTS leg, or for the use of hardware conferencing/transcoding.  So, the number of FXO lines will factor into the number of DSP's needed, as will the need for any hw conferencing.

You can check your DSP needs with the following tool:

http://www.cisco.com/web/applicat/dsprecal/dsp_calc.html

New Member

Re: DSP calculation in SRST mode for ephone

thanks Christopher,

812
Views
0
Helpful
2
Replies