Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

DSP question

Hello,


I want to connect 2 PRIs to a 2811, I'm using the DSP calculator and it says that for 48 calls all g711 u law I need

2 DSP(s).
one PVDM2-32

or

two PVDM2-16

I have a spare PVDM2-64

that should be enough, right?

or do i need 2 PVDM2-64

thanks

also do you have a document that will explain the pvdm types like 2-32, 2-16, 2-64 and so forth

thank you

1 REPLY
Cisco Employee

Re: DSP question

Yes, a PDVM2-64 will be enough and you'll also have some channels left.

Each DS0 from the PRI that carries voice uses 1 channel, and you have 64 on that DSP.

Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html

High-Density Packet Voice Digital Signal Processor Module for Cisco IP Com Sol

http://www.cisco.com/en/US/partner/prod/collateral/routers/ps5854/product_data_sheet0900aecd8016e845_ps3115_Products_Data_Sheet.html

HTH

java


if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
338
Views
3
Helpful
1
Replies
CreatePlease to create content