Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DSP Resources

Can someone tell me which command I can run on a 2821 router to see how much dsp resources I have available after a pri install?

4 REPLIES

Re: DSP Resources

I beleive it is show dsp dsp idle, but that only shows how many are not in use.

Cisco Employee

Re: DSP Resources

you can issue sh voice dsp, it will show resources allocated and which are idle

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Re: DSP Resources

The command 'show voice dsp detailed' should give the detail that you require, it shows the voice dsp channels and the dsp each channel is assigned to.

HTH

Allan.

Pls rate helpful posts.

New Member

Re: DSP Resources

test dsprm 1

278
Views
0
Helpful
4
Replies