Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dsp services

When I go into voice-card 0 and try and do dsp services all it takes is dsp. I am trying to setup conference bridging on my CUCM 6.1. I am using all of my dsps? I am attaching my sh dsp

  • IP Telephony
4 REPLIES

Re: dsp services

Can you post your 'show version' so that we can verify whether you are running into a known issue?

There is certainly no reason why you are unable to use the 'dsp services dspfarm' command under the voice-card 0 for this platform.

Apparently this command was available from IOS 12.2(13)T.

I have checked on a 2811 gateway running 12.4(15)T7 and 12.4(9)T3, and it shouldn't be a problem. Hence it may be IOS defect?

Allan.

New Member

Re: dsp services

I am running 12.4(20) advservices IOS

Re: dsp services

Hi Spencer, I have been looking into this, and I have discovered that the advservices IOS feature set is not a valid IOS release for your hardware requirements.

The software advisor simply does not have the advservices feature set as an available option.

Have you considered or is possible for you to use a different feature set, for example IP Voice release 12.4(21a)?

I have attached a screen shot listing the available feature sets.

HTH

Allan.

New Member

Re: dsp services

I changed the IOS and now I just show one DSP available.

134
Views
0
Helpful
4
Replies