Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DSP sharing for NM-HDV Modue

Hi,

We are using 3845 Router as Gateway.we are using NM-HDV module for conferencing and this module has two PVDM-12 SIMM's. Presently we configured one Transcoder session and 5 Conference session.

Can it possible to do DSP Sharing, because apart from NM-HDV module we are connected Two NM-HDV2-2T1/E1 network modules with two numbers of PVDM2-64 DSP's on each module.

Is it possible to share these DSP(PVDM2-64) Resources for Conferencing with NM-HDV Module.( Presently we are having two numbers of spare PVDM2-64 modules)

If yes, please tell me how to configure and share the DSP resources for NM-HDV conference module.

Please help me out!!

1 REPLY
Hall of Fame Super Silver

Re: DSP sharing for NM-HDV Modue

You can enabled sharing by applying the following:

voice-card 0

dspfarm

Keep in mind that a single DSP cannot be shared between conference bridge and voice termaination or transcoder, however a DSP can be shared beteen voice termination and transcoding. With this beeing said PVDM-64 has 4 DSPs, so when you enable dspfarm on it one of the 4 DSPs can be usued for conferencing and the rest for voice termination and transcoding for example.

HTH,

Chris

256
Views
0
Helpful
1
Replies
CreatePlease to create content