Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dspfarm maximum session problem

Hi,

I am currently setting up a 2620 IOS gateway with an NM-HDV to give my company some additional Transcoding & Confbridge resources.

Due to the memory limits and the IOS l can only configure the basic commands for the DSP Farm (see URL)

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080334294.shtml#backinfo

Going by the example in the URL above with the amount of DSP in the NM-HDV in the router we should be able to configure 3 Confbridges & 12 Transcoding sessions. But when the configuration is applied to the router l can only configure 1 Confbridge or 4 Transcoding sessions -

DSP_VG#DSP_VG(config)#dspfarm transcoder maximum sessions ?

<1-4> Specify the maximum transcoding sessions value

DSP_VG(config)#dspfarm confbridge maximum sessions ?

<0-0> Specify the maximum conferencing sessions value

I have also applied this configuration to a 2620XM router using 12.4 IOS Train and had the same results.

Any suggestions?

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: dspfarm maximum session problem

are you aware that your E1 also takes resources from that pool?

if you look at the show voice dsp you can see 32 channels are already allocated for the E1

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ============

C549 007 01 {medium} 4.1.46 IDLE idle 0 0 1/0:15 01 0 0/0

what you get to configure is what's free of those resources, if you need more sessions add more PVDMs, there are still 2 slots available

SIMM slot 0: Empty.

SIMM slot 1: Empty.

SIMM slot 2: PVDM-12 SIMM present.

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2 REPLIES
Cisco Employee

Re: dspfarm maximum session problem

are you aware that your E1 also takes resources from that pool?

if you look at the show voice dsp you can see 32 channels are already allocated for the E1

TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT

==== === == ======== ======= ===== ======= === == ========= == ===== ============

C549 007 01 {medium} 4.1.46 IDLE idle 0 0 1/0:15 01 0 0/0

what you get to configure is what's free of those resources, if you need more sessions add more PVDMs, there are still 2 slots available

SIMM slot 0: Empty.

SIMM slot 1: Empty.

SIMM slot 2: PVDM-12 SIMM present.

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: dspfarm maximum session problem

Hi Javalenc,

Thanks for getting back with the info you provided above, worked a treat.

Thanks,

James

2215
Views
0
Helpful
2
Replies
This widget could not be displayed.