Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DSPFARMS WITH 2600

I have an 2621XM router with a NM-HDV.It has 5xPDVM-12 dsps. There is a E1(1Port) Multi-Flex Trunk WAN Daughter Card card in the vic slot 0.

Im trying to setup conference resources using the dspfarm confbridge maximum sessions .., the only option available is 0, if I type 0 i receive the following error "No dsp resources available or allocated; check dsp availability

and allocate voice card(s) for dspfarm".

I would like to know how put the 5xPDVM-12 dsps availables for conference and transcoding to be used with the CCME 6.

Thanks.

5 REPLIES

Re: DSPFARMS WITH 2600

Hi Rafael,

Do you have:

Router(config-voicecard)# dsp services dspfarm

Router(config)#dspfarm

Best regards,

- Adrián.

New Member

Re: DSPFARMS WITH 2600

Hi Adrian,

The dsp services dspfarm in voice-card config mode is present in the configuration. The dspfarm command in config mode is not present. Do you think the missing R(cofig)#dspfarm command will solve this? (I had to go to the site to test it).

The IOS is 12.4(23).

Thanks

Re: DSPFARMS WITH 2600

If you do not enable dspfarm services on the voice-card it will show max-sessions 0, yes.

-nick

New Member

Re: DSPFARMS WITH 2600

The problem was fixed changing the codec complexity from high to medium. Now there is 8 sessions for conference. Using the dsp calculator it show that the 5xPDVM-12 are not enough for transconding.

Thanks

Re: DSPFARMS WITH 2600

Hi Rafa,

Good news. Glad you've solved the problem.

5 pts for sharing your solution.

Best regards,

- Adrián.

151
Views
5
Helpful
5
Replies
CreatePlease to create content