Siemens PBX is connected to cisco router using E1 line. This router is configured as h.323 gateway in CUCM. Two way calling between Cisco & Siemens is working fine. If user calls voice mail pilot number from Siemens phone, user gets voice mail prompt. But PIN entered by user from siemens phone is not accepted by Cisco setup.
Is some configuration is required on router or CUCM so that DTMF works between CIsco & Siemens.
You need to check the dialpeer. The siemens pBX is probably connected to a router over isdn or is it IP to the CUCM directly ?Also is the siemens pbx configured in the cucm as a gateway or non gk controlled trunk.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.