We recently upgraded from CM 4.2 to 7.0(1). We did not change our trunking (T1 PRI) via 6608. A user called Verizon Wireless on his Cisco 7940 phone. The Verizon auto attendant required his cell phone number be entered by the phone. It did not recognize any keypad entries, however an analog phone (ATA) off the same switch using the same routing could sent DTMF. The Verizon auto attendant didn't recognize any entries from other Cisco VOIP phones (7940, 7911). Any ideas why?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.