I'm not sure I'm going about this the right way. I have a system that dials across an IP WAN connection into my CME. It dials 1001 which I have setup as the number for an ephone-dn. The system automatically prompts the user to press a button to accept the call. The system doesn't recognize the digit dialed.
When I pick up that same line (1001) and dial the system I can dial digits and the system recognizes it just fine. I have dtmf-relay configured on the outgoing dial-peer for the system.
My question is: how do you add dtmf-relay for an incoming default dial-peer? Or, how else would I accomplish this? TIA.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...