Recently migrated a client from Avaya to Cisco Call Manager System version: 220.127.116.1100-3. The client has a legacy fax number that is no longer a physical device and does not patch in anywhere. The number needs to be retained as clients still use this number The Avaya had a Call FWD applied to a virtual phone which then automatically call forwarded inbound fax messages to a Zeta Fax via a Hunt Pilot. Can this be replicated in Call Manager as the DDI is still used by some old clients.
From the information you give I would guess that the fax system is using T.38 with Fax over IP (FoIP).
You should be able to configure the Cisco system to replicate this although Zetafax is not a Cisco certified product (lots of certified products available if needed from vendors such as Sagem, Stonevoice etc.).
Check out the link below to get started with faxing on Cisco platforms.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...