Duplex Mismatch when connecting ip phone with 2950 switch
When I connect my Cisco IP Phone 7960 with 2950 Switch (any access port within voice vlan), I get the message on Port duplex mismatch but the phone works properly.
From my switch the speed setting is 100/Full but from the Phone its Auto.
My Question is when I try to change duplex settings from Phone, it doesn't gives me any option instead only one option available to save so kindly someone tell me the best way to fix this from Phone or do I have to change the duplex from switch to AUTO ?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...