02-21-2007 02:36 AM - edited 03-14-2019 08:08 PM
Hello,
I'm searching for a procedure to enable the both ethernet ports on the CCM5. By Default, the second ethernet port is inactive.
Thanks for your help
02-21-2007 05:03 AM
Plug both ports in to the switch.
From CLI of Callmanager type the following command,
set network failover enable. (You can use ? after each word for additional options).
HTH
Sankar
PS: please remember to rate posts!
02-21-2007 07:07 AM
Are u trying to use NIC Teaming ?? Remember, that NIC teaming is not supported on all CM 5.x versoin and HW. It would only work on HP servers with CM 5.0(4) and later
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: